All Ethernet-DMX
In this setup, the connected merchandise are used as
single output boxes
(Ethernet to DMX) connected to any quite ArtNet supply
(lighting
software, lighting table, media server...
See artnet controller at
http://icontrol.com.vn/artnet-controller-0.html
Output Box
Related merchandise :All Ethernet-DMX. In this setup, the
connected merchandise are used as single output boxes(Ethernet to DMX)
connected to any quite ArtNet supply (lighting
software, lighting table, media server...).
Connect your Ethernet-DMX device to its ArtNet supply.
Use a cross-cable
if you connect your Luminex device on to the ArtNet
supply.
Be sure your Ethernet-DMX device is about with associate
degree information science address among the
same information science vary because the ArtNet supply.
typically ArtNet devices use two.x.x.x or
10.x.x.x information science addresses.
All Luminex Ethernet-DMX product is set either from the
forepart or
through the inherent internet server. If your ArtNet
supply doesn't have a
Web browser, set your Luminex device from the forepart ,
either by
loading an entire “output” profile or by setting every
outlet one by one
with the specified universe addresse and mode.
If you are able to achieve the inherent internet server
of your Luminex device, you
should see Illustration 2: Loading associate degree
"All out 0" profile samples of output
configurations, that is achieved by loading associate
degree output profile (All OUT 0)
or you can see Illustration 3: Setting all shops
individually by setting all
outlets individually.
No comments:
Post a Comment